Functions in the Options menu 37
Functions in the Options
menu
What this chapter contains
The chapter describes functions in the Options menu.
Sub-menus
Through the Options menu, you can control the settings
related to the Home view. The menu has the following
items:
• Reference: Set the reference value. The changes
take place only when you save them with a key
press. See Setting the reference below.
• Direction change: Change the direction of the motor’s rotation in local control
mode.
• Select drive: Enable or disable the panel bus, and if enabled, view the status
of drives in the panel bus and select which drive to control with the control
panel. See chapter Control of multiple drives on page 41.
• Edit Home view: Edit the contents of the Home view. See Editing the
contents of the Home view below.
• Fault status: View an active fault or warning. See chapter Fault tracing on
page 45.
Assistant Panel Guide Rev B.book Page 37 Tuesday, April 10, 2012 12:08 PM
To Next Page
Loading...
