38 Functions in the Options menu
Setting the reference
You can change the reference when the drive is in the local control mode. You can
also change the reference in remote control if the drive configuration permits it (ie, the
(Remote) mode). Changes take effect when saved with a key press.
1. If the text in the top left corner of the display reads Remote, switch to the local
control mode by pressing .
2. In the Options menu, select Reference.
3. Change the reference by using the following keys:
• Use or to select a digit to edit.
• Use and to change the value of the selected digit.
4. Press
(Save) to save the reference value, or (Cancel) to discard the
changes. The control panel returns to the Home view.
Tip: To adjust the reference straight from the Home view,
press or and the reference changes immediately. The
reference value is highlighted when you are changing it. If
you hold down the arrow key, the rate at which the value
changes accelerates.
Editing the contents of the Home view
1. In the Options menu, select Edit Home view. This opens the Home view in the
editing mode.
In the editing mode, you can add, edit and delete the displayed parameters.
When finished, press (Done) in the Home view to confirm the changes, to
exit the editing mode and to return to the Home view.
2. In the editing mode, use and
to move between the different pages of the
Home view.
• To add a new page, navigate to the page that reads Press “Add” to make a
new screen.
• To edit, add or delete parameters on an existing page, navigate to that page.
3. Use and to move the cursor highlight.
• To add a new parameter to an existing page, highlight an area above, between
or below an existing parameter.
Two-signal page in editing mode Empty page in editing mode
Softkey labels and a blinking
cursor indicate that the
control panel is in the editing
mode.
Assistant Panel Guide Rev B.book Page 38 Tuesday, April 10, 2012 12:08 PM
To Next Page
Loading...
