3BHS799208 E01 REV E ACS5000 WATER-COOLED USER MANUAL 105/186
06 ELECTRICAL INSTALLATION
6.7 Power cables, ground cables, equipotential
bonding conductor
See Appendix A – Additional manuals for information on:
• Project-specific cable entry
• Distance between point of cable entry and terminals
• Busbar and fastening hole dimensions
• Installation instructions for sealing modules
See Appendix D – Wiring diagrams for information on:
• Designation, cross-reference and device identification conventions
• Transformer cables and motor cables and their
corresponding connections
6.7.1 Preparing the cable entry and the cables
6.7.1.1 Determining the cable length
1. Determine the required length of a cable between the point of entry
and the connection point inside the cabinet.
2. Cut the cable to the required length before connection.
▲NOTICE
Risk of damage or malfunction!
Waste inside the cabinet can cause damage or malfunction.
• If possible, do not cut cables inside the terminal compartment.
• Retrieve any waste which accidentally dropped into the cabinet.
To Next Page
Loading...
Need help?
General
