ABB ACS5000 - Page 11

10.4 Removing the CDP control panel 165
10.5 LEDs and switches on circuit boards and I/O devices 166
10.5.1 AMC circuit board 167
10.5.2 S800 I/O bus modem TB820 168
10.5.2.1 Bus modem address 168
10.5.3 S800 I/O modules 169
10.6 Corrective maintenance 169
10.6.1 Safety 171
10.6.2 De-energizing the drive 172
10.6.2.1 Stopping the motor 172
10.6.2.2 De-energizing the drive 172
10.6.3 Opening and closing the doors 174
10.6.4 Grounding switch is not released 176
10.6.5 Emergency release of a door safety switch 177
10.6.5.1 Location of safety switches 177
10.6.5.2 Safety-switch settings 178
10.6.6 Visual checks on the drive 179
10.6.7 Cleaning§ 180
10.6.7.1 Cleaning the drive cabinet 180
10.6.8 Checking wire and cable connections 181
10.6.9 Checking and replacing filter mats 181
10.6.9.1 Location 181
10.6.9.2 Replacing filter mats 181
10.6.10 Replacing a door-mounted fan 182
10.6.11 Replacing a fan of an IP42 roof-mounted cooling unit 183
10.6.11.1 Replacing a fan 183
10.6.12 Replacing a fan of an IP54 roof-mounted cooling unit 184
10.6.12.1 Replacing a fan 184