SHB_U14 Chapter 7: Configuration 7-1
Chapter 7: Configuration
Overview
Introduction
This chapter contains information on configuring the hardware and software of an
analyzer module.
The operator’s manual describes the method of configuring via the central unit
keypad.
Contents
In this chapter you will find the following information:
Subject See page
Hardware configuration 7-2
Software configuration with TCT 7-4
General data 7-6
IR detectors 7-8
Temperature detectors 7-31
Pressure detector 7-36
Flow detector 7-40
Calibration Cell 7-45
Solenoids 7-46
Pump 7-48
To Next Page
Loading...
