7-36 Chapter 7: Configuration SHB_U14
Pressure detector
General
The pressure detector (pressure 1) is always installed in the analyzer module and
thus is always configured. This detector is used to compensate for the process-
related pressure relationship of the sample value.
Detector
configuration
Detector
Detector type: Pressure detector 1
Active Component Air pressure in hPa
Correction functions None
Update mode Applies to detector raw measurement value; default:
Cyclical
Cycle Time Default: 5000ms
Delta Offset: Not applicable to auxiliary detectors
Delta amplification Not applicable to auxiliary detectors
Over Offset Not applicable to auxiliary detectors
Over amplification Not applicable to auxiliary detectors
Classification Variables or variables display
"Variables display" invokes a display on the AO screen
Continued on next page
To Next Page
Loading...
