SHB_U14 Chapter 7: Configuration 7-39
Pressure detector, continued
Start/span correction
parameters
Position
Display
Offset correction
variable
Not applicable to auxiliary detectors
Ampl. variable Not applicable to auxiliary detectors
Offset fixed Start point correction, determined during an initial
calibration.
This value is only overwritten by a new initial calibration.
Ampl. fixed Sensitivity, determined during an initial calibration.
This value is only overwritten by a new initial calibration.
Start point desired
value
Air pressure display for initial zero calibration
Desired Span Value Air pressure display for initial span calibration
Start point raw value Raw value display (initial zero calibration)
Span raw value Raw value display (initial span calibration)
Note
The pressure detector is generally only calibrated at the zero point (offset).
Sensitivity (amplif. fixed) is preset for the type of pressure sensor used.
To Next Page
Loading...
