ABB COMMANDER 351 - Page 56

54
4.6 Level A – Control Configuration
Note. Level A is not displayed if an indicator template is selected.
…4 CONFIGURATION MODE
Level A – Control Configuration
Note. To select this frame from anywhere in this page, press and
hold the
key for a few seconds.
Power Fail Recovery Mode
Select the default power failure mode required following a power
interruption or failure.
Recovery Time
If power is restored within the recovery time, the controller continues in
the last mode when power fail recovery modes 7 or 8 are selected.
[0 to 9999 seconds]
Continued…
CntL
LEVA
A.00
0
rEC.t
A.02
0
P.rEC
A.01
•1
A.00...A.02
yalpsiDgnitteSyalpsiDgnitteS
0
edomtsaL
5
,edomotuA
tesermretlargetni
1
,edomlaunaM
tuptuotsalgnisu
6
,edomotuA
mretlargetnitsalgnisu
2
htiwedomlaunaM
tuptuo%0.0
7
egatuorewoP ≤
otuA:emityrevoceR
>egatuorewoP.edom
launaM:emityrevoceR
tuptuotsal,edom
3
htiwedomlaunaM
tuptuo%0.001
8
egatuorewoP ≤
otuA:emityrevoceR
>egatuorewoP.edom
launaM:emityrevoceR
tuptuoderugifnoc,edom
4
htiwedomlaunaM
tuptuoderugifnoc
•1 Not displayed if power fail modes 0 to 6 are selected.