II K 2-6
Operation by PC
Components :
RS232 standard cable, 9-pin sub-D connector,
male-female, non-crossing
Functionality:
Software package "Drive Window Light"
System requirements/recommendation:
PC with 386 processor or higher
hard disk with 5 MB free memory
VGA monitor
Windows 3.1, 3.11, 95, 98, NT
3 1/2" floppy disk drive
Start-up wizard
The start-up wizard makes it easier to parameter-
ize and optimize a drive. It guides the user
through the various sequences involved in a
start-up.
Drive Window Light
Drive Window Light is a PC tool for on-line start-
up, diagnosis, maintenance and troubleshooting.
System configuration display
offers an overview the system.
Drive control
to be used for control of a selected drive.
Parameter programming
to be used to process signals and parameters of
the destination drive.
Trending
monitors the feedback values of the destination
drive.
Fault logger
enables you to view the error memory.
Fig. 2.4/2: Example for a Start-up wizard display
System overview of DCS 400
CAUTION!
To avoid unintentional operating states, or to shut
the unit down in case of any imminent danger
according to the standards in the safety instruc-
tions it is not sufficient to merely shut down the
drive via signals 'RUN', drive 'OFF' or 'Emergency
Stop' respectively 'control panel' or 'PC tool'.
To Next Page
Loading...
