ABB DCS 400 - Panel Operations

II K 6-4
Operating Instructions
Cancel function, back to
Select Type with
(17(5
.
Read Faultlogger
OUTPUT MEN U AUTO OFF HAND REM
LOC <RUN>
Faultlogger empty
Press ENTER
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
Clear Faultlogger
No
Yes
OUTPUT MEN U AUTO OFF HAND REM
LOC <RUN>
Eme Stop Pending
02: -A 09
External Alarm
03: A 12
...
OUTPUT MEN U AUTO OFF HAND REM
LOC <RUN>
HLWKHU
RU
Confirm the right
Typekey with
(17(5
.
Reboot the drive system
by switching the electron-
ics Off and On.
If the Faultlogger is emp-
ty this message will ap-
pear, back to OUTPUT
Display with
(17(5
.
If there Faultlogger con-
tents a message (as ex-
ample) will appear.
The - sign before the A
means the alarm is exist-
ing in this moment no
longer. Use the
keys for scrolling in the
Faultlogger. To escape
the Faultlogger press the
(17(5
or
0(18
key.
The Faultlogger contents
will be deleted, back to
OUTPUT Display with
(17(5
.
The Faultlogger is de-
leted during shut-down
of electronics supply.
Set Typecode
Only visible in Long Par List.
Disabled if the drive is in ON-state.
Read Faultlogger
Use only for replacement
of SDCS-CON-3A.
Select 'Yes' for Typecode
adaptation.
Enter correct PIN number
('400').
See converter name
plate and select the same
type in the list.
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
0
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
DCS401.0020
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
DCS401.0045
DCS401.0065
...
DCS402.1000
DCS402.0025
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
Revision
OUTPUT MENU AUTO OFF HAND REM
LOC <RUN>
Rev A.x
Set Typecode
Modify Typecode?
No
Enter PIN Code
Select Type
Cancel
Storing (10s)
Please wait
PleaseReboot
Yes
Confirm
Without
Read from converter
name plate
• DCS40x.xxx
• DCS40x.xxxx Rev A.x
Select and confirm with
(17(5
.
Non-volatile memory - 16
entries.