Revision: Language: Page:
A EN 2/37
1KHW001493-EN
Basic test equipment
PC with Windows 2000 or XP
HMI600 software Newest version
PC Ù P4LT serial cable RS-232 Sub-D 9-pole 1:1
Digital multimeter GMC METRAhit one, or equivalent
Level meter True RMS with a frequency range up to 1 MHz
Dummy load P3LK (up to 500 kHz) HENF331084
Optional test equipment
Level generator PS-33A (Acterna) or equivalent
Selective level meter SPM-33A (Acterna) or equivalent
Storage oscilloscope Fluke 190C ScopeMeter or equivalent
Tx tuning adapter P3LL HENF 209668
Rx tuning adapter P4LM HENF 209665
Data tester PFA-35 (Acterna) or equivalent
Notes:
)
• This document is part of instruction manual 1KHW001489.
• Please refer 1KHW001490 for compatibility between software HMI600, firmware and
hardware of ETL600.
Designations and abbreviations used:
Designation Meaning
___________ Measured value
[ ... ] Programmed value
[ ] D Preferred setting (default)
[ X ] Test passed or jumper is set
[ ] Not tested or jumper is not set
B5LA Module type
BER Bit Error Ratio
Def. Default value
equ. Equipment
f
Lo
Lower frequency, usually meant as low cut-off frequency
LED Light Emitting Diode found on the front panel
HMI600 User Interface Program for ETL600 running on a PC
N11, …, N71 Position in rack. Slot number N11, …, N71
Rx Receiver
Tx Transmitter
PC Personal Computer
X11, …, X71 Position in rack. Equivalent to N11, …, N71
To Next Page
Loading...
