ABB ETL600 - Page 309

Revision: Language: Page:
ETL600 System Settings
_ EN A1/A4
HE
No. Action Rack or
module
Item to be
programmed or
fitted
Selected
alternative or
setting
Remarks
A.1 General
A.2 Create a configuration file using
HMI600
HMI600 [ ]
A.3 Racks and assemblies
A.3.1 Number of P7LA racks
Configuration file shows the correct
number of P7LA racks.
Config file [ ]
Refer to
hardware
A.3.2 Assemblies in upper rack P7LA, if
present
Configuration file shows the correct
type of power supply B5LA or B5LC
in upper rack P7LA.
Config file [ ]
Refer to
hardware
All assemblies in upper rack P7LA
are mounted at the correct positions
Upper* P7LA Assemblies [ ]
Refer to config
file
A.3.3 Assemblies in lower rack P7LA
Configuration file shows the correct
type of power supply B5LA or B5LC
in lower rack P7LA.
Config file [ ]
Refer to
hardware
All assemblies in lower rack P7LA
are mounted at the correct positions
Lower P7LA Assemblies [ ]
Refer to config
file
A.3.4 Assemblies in rack P7LC
Configuration file shows the correct
number and type of assemblies in
rack P7LC.
Config file [ ]
Refer to
hardware
All assemblies in rack P7LC are
mounted at the correct positions
P7LC Assemblies [ ]
Refer to config
file
A.3.5 Check presence of spare plates in
rack P7LC.
Front of rack is completely covered P7LC Spare plates [ ]
A.4 Settings for basic equipment
ETL640/80
A.4.1 Power amplifier P1LA
Upper
*
Lower
Wire bridges set according to
configuration file
P1LA BB, DD, EE, FF [ ] [ ]
A.4.2 Settings for B5LC, if present
Upper* Lower
Wire bridges and fuses correct for
specified supply voltage
B5LC
Wire bridges and
fuses
[ ] [ ]
Refer to
1KHL015788
*
‘Upper’ und ‘Lower’ stands for upper rack / lower rack and applies to 80 W equipment ETL680 only.
© ABB Switzerland Ltd Form 1KHW001493-EN
Rev. A