Appendix A – PROFIdrive parameters 185
927 R/W Unsigned16 Operator control rights (parameter
identification, PKW)
928 R/W Unsigned16 Control rights (process data, PZD).
929 R Unsigned16 Selected PPO type
Par. no. R/W
1)
Data type Description
Value Mode
0 Parameters cannot be written,
only read (927 can be written).
1 Parameters can be written and
read (default).
Value Mode
0 PZD part is disabled, ie,
Receipt of new PZD data is
ignored.
1 PZD part is enabled (default).
Value PPO type Configuration
1PPO1 F3h, F1h
2PPO2 F3h, F5h
3PPO3 F1h
4PPO4
F5h
5PPO5 F3h, F9h
6PPO6 F9h
7PPO7 0xF3, 0xFB
8 PPO8 0xFB
Note: This parameter is not available if
standard telegram ST1 or ST2 is
selected.
To Next Page
Loading...
