ABB FSM4000-SE41F - Connecting the Flowmeter Sensor; Connecting the Signal and Magnet Coil Cables

Electrical connections
D184B140U02 FSM4000 35
5.2 Connecting the flowmeter sensor
5.2.1 Connecting the signal and magnet coil cables
The flowmeter sensor is connected to the transmitter via the signal / magnet coil cables (part
no. D173D025U01 / D173D147U01). The coils of the flowmeter sensor are supplied with a field
voltage by the transmitter over terminals M1/M3. Connect the cables to the flowmeter sensor
according to the following drawing, using a screwdriver with proper size and width.
G00553
SE
SE
3A
3A
1S
2S
12 3
16
16
M1
M3
1
2
3
6
5
7
4
6
9
8
G00554
SE
SE
3A
3A
U- U+
12
3
16
16
M1
M3
1
2
3
6
5
7
4
6
9
8
Terminal box without preamplifier Terminal box with preamplifier
Fig. 32
1 red
2 blue
3 yellow
4 white
5 black
6 SE clamp
7 Signal cable
8 Grounding screw
9 Ma
g
net coil cable
1 red
2 blue
3 yellow
4 white
5 black
6 SE clamp
7 Signal cable
8 Grounding screw
9 Ma
g
net coil cable
Terminal designation Connection
1 + 2 Wires for the measuring signal
1S, 2S Shielding for signal wires
U+, U- Power supply for preamplifier via signal cable shielding
16 Cable for reference signal
3A Shielding for reference signal cable
3 Measuring ground (yellow)
M1 + M3 Connections for magnetic field excitation (black)
SE Outer cable shield