Parameterization
D184B140U02 FSM4000 73
Submenu/parameter Value range Comment
Totalizer → F Numerical entry
0 ... 9999999
Display or input the forward totalizer value.
0.0 kg/h
Overflow ← R Display only Overflow counter max. 65535. 1 overflow = pulse totalizer
of 9,999,999 units. Resets the display status and
increments the overflow counter by one.
0
Totalizer ← R Numerical entry
0 ... 9999999
Display or input the reverse totalizer value.
0
Reset totalizer Select ENTER to reset the forward/reverse flow totalizer
and overflow counters.
Overflow Diff. Display only Display the overflow for the diff. totalizer.
0
Totalizer Diff. Numerical entry
0 ... 9999999
Display or input the diff. totalizer value.
0.0 kg/h
Submenu This menu does not appear for the PROFIBUS PA or
FOUNDATION fieldbus.
Current output
Current output 0 - 20 mA, 4 - 20 mA
0 - 10 mA, 2 - 10 mA
Select the current output range.
For HART protocol always 4 - 20 mA.
0 - 20 mA
Iout for alarm Low Alarm
High Alarm
Behavior of the current output during an alarm. Low-
Alarm is available only for current output of 2 - 10 mA and
4 - 20 mA. If error 0 (empty pipe) occurs, the current
output is set to the value programmed for the parameter
"lout during empty pipe" in the submenu "Detector empty
pipe". If error 3 (flowrate > 103 %) occurs, "High Alarm" is
always signaled.
Low Alarm
Iout low alarm Numerical entry
Low-Alarm is available only for current output of 2 -10 mA
or 4 - 20 mA. Set the current output value during Low
Alarm condition. No selection available if High Alarm is
selected for the current output selection for lout during
alarm and if the transmitter version is standard and the
current output range is
0 - 20 mA
0 - 10 mA
.
3.60 mA
Iout high Alarm Numerical entry Set the current output value during High Alarm condition.
If error 3 (flowrate > 103 %) occurs, "High Alarm" is
always signaled. No selection available for current output
if Low Alarm is selected for lout during Alarm.
21.80 mA
Error 3 mask Off, On Deactivates error 3 (flowrate > 103%), if masking = on
Off
Error 4 mask Off, On Deactivates error 4 (ext. zero return), if masking = on
Off
To Next Page
Loading...
