ABB i-bus EIB

Commissioning
© 2006 ABB STOTZ-KONTAKT GmbH 101
ABB i-bus
®
EIB / KNX
3.4.6.1 Insert new daylight saving time
Fig. 108: Dialog window: “Insert new daylight saving time”
To insert a daylight saving time, first select Time switch program in the
selection area followed by Daylight saving times.
The associated table is activated in the right-hand window.
The table is divided into Year, Start, End and Offset.
The meaning of the individual columns is as follows:
Year
The year is displayed in this column.
Start
The start of the daylight saving time is displayed in this column.
End
The end of the daylight saving time is displayed in this column.
Offset
The time adjustment (offset) is displayed in this column.