ABB i-bus EIB - Exponent

Commissioning
© 2006 ABB STOTZ-KONTAKT GmbH 71
ABB i-bus
®
EIB / KNX
Exponent
Options: Auto /
0…3 (Temp.)
…15
This parameter is used to select which exponent is assigned to the object
value.
Note: Different object values can be set, depending on the exponent
which is selected. The table below shows all the options.
Exponent Object value
Auto -671,088.64…0.00…670,760.96
0 -20.48…0.00…20.47
1 -40.96…0.00…40.94
2 -81.92…0.00…81.88
3 (Temp.) -163.84…0.00…163.76
4 -327.68…0.00…327.52
5 -655.36…0.00…655.04
6 -1,310.72…0.00…1,310.08
7 -2,621.44…0.00…2,620.16
8 -5,242.88…0.00…5,240.32
9 -10,485.76…0.00…10,480.64
10 -20,971.52…0.00…20,961.28
11 -41,943.04…0.00…41,922.56
12 -88,386.08…0.00…83,845.12
13 -167,772.16…0.00…167,690.24
14 -335,544.32…0.00…335,380.48
15 -671,088.64…0.00…670,760.96
Table 5: Exponent