ABB i-bus EIB

Commissioning
© 2006 ABB STOTZ-KONTAKT GmbH 104
ABB i-bus
®
EIB / KNX
Start, End
The daylight saving time is defined by entering the date (on) and time (at) of
the start and end.
The date for the start and end can be set in a range between 1.1.2000 and
31.12.2035. The representation is in numbers which are separated by full
stops in the sequence Day. Month. Year. Entries for the year in the range
36...99 are rejected. To the right of the input field for the date, there is a
button with which the calendar for the current date can be displayed. The
input of the date for the start and end can be carried out via the selection of
a date in the calendar or through the direct input of the date.
The displays for the hour can be edited via the buttons Left arrow and Right
arrow.
Offset
An offset, i.e. the time adjustment can be set.
Note: With the start of the daylight saving time, the current time of the
internal clock is adjusted by this value and reset with the end of
the daylight saving time.
“Insert” button
The settings are adopted via the “Insert” button.
“Close” button
When the “Close” button is pressed, the function is ended and the parameter
window closes.
“Help” button
The “Help” file can be opened directly via the “Help” button and a further
parameter window Help for application program… is opened.