ABB i-bus EIB User Manual

ABB i-bus
®
KNX
Commissioning
180 2CDC508134D0202 | FCA/S 1.x.x.1
3.2.4.2.2 Parameter Distinction between long and short operation – Yes
If the option Yes has been selected with the parameter Distinction between long and short operation, the
following parameters appear in Parameter window a: Switch sensor, p. 171:
Short operation -> Event 0
Long operation -> Event 1
<−−− NOTE
Input on operation
Options:
open
Closed
 Open: The input is opened with actuation.
 Closed: The input is closed with actuation.
If a normally open contact is connected to the input, the option Closed should be selected; on a
normally closed contact the option Open should be selected.
Long operation after …
Options:
0.6/0.8 s
1/1.2/1.5 s
2/3/4/5/6/7/8/9/10 s
Here the time period T
L
, after which an operation is considered a “long” operation, is defined.
Note
The remaining parameter descriptions can be found in Parameter Distinction between long
and short operation – No, p. 173.

ABB i-bus EIB Specifications

General

Brand	ABB
Model	i-bus EIB
Category	Controller
Language	English