NoteAction
CAUTION
The upper arms, which includes housing, extender
unit (only for IRB 1300-7/1.4 and IRB 1300-12/1.4),
tubular and tilt unit weighs 17 kg.
All lifting accessories used must be sized accord-
ingly!
4
Fit a roundsling to the upper arm to support the
weight (no force).
5
xx2000001614
Loosen the screws and move the motor slightly
to slacken the timing belt.
6
xx2000001615
Remove the timing belt from its groove on the
motor.
7
Separating the lower arm from the housing
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 145.
2
Continues on next page
Product manual - IRB 1300 377
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.5.2 Replacing the housing and extender unit
Continued
To Next Page
Loading...
