4.7.2 Changing oil, axis-1 gearbox
Location of oil plugs
The oil plugs of the gearbox are located as shown in the figure.
xx2000001511
Oil plug, filling and ventingA
Quick coupling, drainingB
Required tools and equipment
NoteArticle numberEquipment, etc.
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
-Oil collecting vessel
Used for draining and filling oil to axis-
1 gearbox.
Connector specification: G3/8
-Connector for quick coupling,
with outlet pipe
Includes pump with outlet pipe.-Oil dispenser
Content is defined in section Standard
toolkit on page 759.
-Standard toolkit
Consumable
NoteMaterial
Information about the oil is found in Technical refer-
ence manual - Lubrication in gearboxes.
Lubricating oil
See Type and amount of oil in gearboxes on page 129.
Continues on next page
130 Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
4 Maintenance
4.7.2 Changing oil, axis-1 gearbox
To Next Page
Loading...
