ABB IRB 1300 - Axis Calibration - Running the Calibration Procedure

6.4.4 Axis Calibration - Running the calibration procedure
Required tools
The calibration tools used for Axis Calibration are designed to meet requirements
for calibration performance, durability and safety in case of accidental damage.
WARNING
Calibrating the robot with Axis Calibration requires special calibration tools from
ABB. Using other pins in the calibration holes may cause severe damage to the
robot and/or personnel.
NoteArticle numberEquipment, etc.
Delivered as a set of calibration tools.
Required if Axis Calibration is the valid
calibration method for the robot.
3HAC074119-001Calibration toolbox, Axis Cal-
ibration
Required consumables
NoteArticle numberConsumable
-Clean cloth
Spare parts
NoteArticle numberSpare part
Replace if damaged or missing.3HAC053237-003Protective plug for 10-mm
bushing
Replace if damaged or missing.3HAC053237-002Protective plug for 12-mm
bushing
Replace if damaged or missing.3HAC056253-003Calibration pin cover, 10 mm
Replace if damaged or missing.3HAC056253-002Calibration pin cover, 14 mm
Replace if damaged or missing.3HAC061327-022O-ring on calibration pin
Replace if damaged or missing.3HAC061327-011O-ring on calibration pin
Used with protection type Clean Room.
Replace if damaged or missing.
3HAC077381-001Rubber sealing washer with
10-mm protective cover
Used with protection type Clean Room.
Replace if damaged or missing.
3HAC075324-001Rubber sealing washer with
12-mm protective cover
Used with protection type Clean Room.
Replace if damaged or missing.
3HAC075325-001Rubber sealing washer for 10-
mm calibration pin cover
Used with protection type Clean Room.
Replace if damaged or missing.
3HAC075323-001Rubber sealing washer for 14-
mm calibration pin cover
Overview of the calibration procedure on the FlexPendant
The actual instructions of how to perform the calibration procedure and what to
do at each step is given on the FlexPendant. You will be guided through the
calibration procedure, step by step.
Continues on next page
730 Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
6 Calibration
6.4.4 Axis Calibration - Running the calibration procedure