Spare parts
When calibration is not being performed, a protective cover and an o-ring should
always be installed on the fixed calibration pin as well as a protective plug, included
a sealing, in the bushing. Replace damaged parts with new.
NoteArticle numberSpare part
Replace if damaged or missing.3HAC053237-003Protective plug for 10-mm
bushing
Replace if damaged or missing.3HAC053237-002Protective plug for 12-mm
bushing
Replace if damaged or missing.3HAC056253-003Calibration pin cover, 10 mm
Replace if damaged or missing.3HAC056253-002Calibration pin cover, 14 mm
Replace if damaged or missing.3HAC061327-022O-ring on calibration pin
Replace if damaged or missing.3HAC061327-011O-ring on calibration pin
Used with protection type Clean Room.
Replace if damaged or missing.
3HAC077381-001Rubber sealing washer with
10-mm protective cover
Used with protection type Clean Room.
Replace if damaged or missing.
3HAC075324-001Rubber sealing washer with
12-mm protective cover
Used with protection type Clean Room.
Replace if damaged or missing.
3HAC075325-001Rubber sealing washer for 10-
mm calibration pin cover
Used with protection type Clean Room.
Replace if damaged or missing.
3HAC075323-001Rubber sealing washer for 14-
mm calibration pin cover
Product manual - IRB 1300 729
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
6 Calibration
6.4.3 Installation locations for the calibration tools
Continued
To Next Page
Loading...
