ABB IRB 1300 - Page 508

NoteArticle numberSpare part
Used for IRB 1300-10/1.15, IRB
1300-7/1.4 and IRB 1300-12/1.4.
Used with protection classes IP40
and IP67.
Used with protection type
Foundry Plus.
3HAC073096-001Swing cover, long
Used with protection classes IP40
and IP67.
Used with protection type
Foundry Plus.
3HAC073092-001Lower arm cover
Used with protection type Clean
Room.
3HAC077824-001Swing cover, short, Clean Room
Used for IRB 1300-10/1.15, IRB
1300-7/1.4 and IRB 1300-12/1.4.
Used with protection type Clean
Room.
3HAC077825-001Swing cover, long, Clean Room
Used with protection type Clean
Room.
3HAC077821-001Lower arm cover, Clean Room
Used for IRB 1300-11/0.9.
Not used with protection class
IP40.
Replace if damaged.
3HAC067824-001Gasket for swing cover, short
Used for IRB 1300-10/1.15, IRB
1300-7/1.4 and IRB 1300-12/1.4.
Not used with protection class
IP40.
Replace if damaged.
3HAC067825-001Gasket for swing cover, long
Not used with protection class
IP40.
Replace if damaged.
3HAC067832-001Gasket for lower arm cover
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit on page 759.
-Standard toolkit
Delivered as a set of calibration
tools.
Required if Axis Calibration is the
valid calibration method for the
robot.
3HAC074119-001Calibration toolbox, Axis Calibra-
tion
Used to release the motor brakes.-24 VDC power supply
Length: 1.7 m
Lifting capacity: >400 kg
-Roundsling, 1.7 m
-Overhead crane
Required consumables
NoteArticle numberConsumable
-Cable straps
Continues on next page
508 Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.6.2 Replacing the axis-2 motor
Continued