NoteArticle numberSpare part
Not used with protection class
IP40.
Replace if damaged.
3HAC032050-001Seal bolt
Used with protection types Clean
Room and Foundry Plus.
Replace if damaged.
3HAC070148-003Radial sealing on swing (to base)
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit on page 759.
-Standard toolkit
Delivered as a set of calibration
tools.
Required if Axis Calibration is the
valid calibration method for the
robot.
3HAC074119-001Calibration toolbox, Axis Calibra-
tion
Used to release the motor brakes.-24 VDC power supply
The capacity of the vessel must
be sufficient to take the complete
amount of oil.
-Oil collecting vessel
Used for draining and filling oil to
axis-1 gearbox.
Connector specification: G3/8
-Connector for quick coupling, with
outlet pipe
Includes pump with outlet pipe.-Oil dispenser
Included in special toolkit
3HAC076396-001.
-Axis-1 gearbox assembly cap
Length: 1.7 m
Lifting capacity: >400 kg
-Roundsling, 1.7 m
-Overhead crane
Used with protection class IP67,
and protection types Clean Room
and Foundry Plus.
Used for the press-fitting of radial
sealings. Includes five sets of ra-
dial sealing assembly tool for
axes 1 to 4 and axis 6.
3HAC078203-001Special toolkit for IP67/Clean
Room/Foundry Plus robots
Required consumables
NoteArticle numberConsumable
-Cable straps
FM 2223HAC029132-001Grease
Kyodo Yushi TMO1503HAC032140-001Lubricating oil
Loctite 577-Flange sealant for conical fittings
Continues on next page
Product manual - IRB 1300 583
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.7.1 Replacing the axis-1 gearbox
Continued
To Next Page
Loading...
