NoteArticle numberSpare part
Not used with protection class
IP40.
Replace if damaged.
3HAC067832-001Gasket for lower arm cover
Not used with protection class
IP40.
Replace if damaged.
3HAC032050-001Seal bolt
Not used with protection class
IP40.
Replace if damaged.
3HAC070148-005Radial sealing on lower arm
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit on page 759.
-Standard toolkit
Delivered as a set of calibration
tools.
Required if Axis Calibration is the
valid calibration method for the
robot.
3HAC074119-001Calibration toolbox, Axis Calibra-
tion
Used to release the motor brakes.-24 VDC power supply
Used for measuring the timing
belt tension.
-Sonic tension meter
Used with protection class IP67,
and protection types Clean Room
and Foundry Plus.
Used for the press-fitting of radial
sealings. Includes five sets of ra-
dial sealing assembly tool for
axes 1 to 4 and axis 6.
3HAC078203-001Special toolkit for IP67/Clean
Room/Foundry Plus robots
Required consumables
NoteArticle numberConsumable
-Cable straps
FM 2223HAC029132-001Grease
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
NoteAction
Note
Calibrating axis 6 always requires tools to
be removed from the mounting flange (also
for reference calibration) since the mount-
ing flange is used for installation of the
calibration tool.
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
1
Continues on next page
640 Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.7.3 Replacing the axis-3 gearbox
Continued
To Next Page
Loading...
