NoteAction
xx2000001614
Loosen the screws and move the motor slightly
to slacken the timing belt.
6
xx2000001615
Remove the timing belt from its groove on the
motor.
7
Separating the lower arm from the housing
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 145.
2
xx2000001664
Remove the screws.
WARNING
This releases the upper arm from the lower arm.
Make sure the weight of the upper arm is properly
secured.
The upper arm, including housing, extender unit
(only for IRB 1300-7/1.4 and IRB 1300-12/1.4), tu-
bular and tilt unit, weighs 17 kg.
3
Continues on next page
654 Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.7.3 Replacing the axis-3 gearbox
Continued
To Next Page
Loading...
