Refitting the axis-4 motor
NoteAction
For robots with protection type Clean Room:1
Clean the joints that have been opened and wipe
the parts free from particles with spirit on a lint
free.
Check that:
• all assembly surfaces are clean and without
damages
• the motor is clean and undamaged.
2
xx2000001670
Install the timing belt to the gearbox pulley and
verify that the belt runs correctly in the grooves
of the pulley.
3
Motor orientation: orient the motor
according to the figure below, in
regard to the encircled motor con-
nector.
xx2000001607
Orient the motor correctly and fit it into the hous-
ing.
Note
Make sure the motor flange does not press on the
timing belt.
4
xx2000001680
Refit the motor and verify that the timing belt runs
correctly in the groove of the motor pulley.
5
Continues on next page
700 Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.7.4 Replacing the axis-4 gearbox
Continued
To Next Page
Loading...
