Refitting, turning disk
Use this procedure to refit the turning disk.
NoteAction
Art. no. is specified in Required equip-
ment on page 217.
xx0200000218
• A: Sealing surface, o-ring
Lubricate the o-ring of the turning disk with
grease and fit it to the turning disk.
Also fit the 12 o-rings, when refitting the attach-
ment screws.
1
xx1400000995
Foundry Plus:
Apply Loctite 574 flange sealant on the contact
surface.
2
Continues on next page
Product manual - IRB 6660 219
3HAC028197-001 Revision: S
© Copyright 2007-2018 ABB. All rights reserved.
4 Repair
4.4.1 Replacing the turning disk
Continued
To Next Page
Loading...
