NoteAction
Art. no. is specified in Required equip-
ment on page 244.
Refit the shaft (A) by pressing it through the
parallel bar with the fitting/removing tool.
7
See figure above!
Loctite 243Apply locking liquid in the hole of the lock
screw.
8
xx1000001349
Lock screw: M6x16
Plain washer: 6.4x12x1.6
Refit the lock screw and plain washer.9
xx1000001352
Lift the parallel rod up into position for fitting
the upper end.
10
Refit the upper end of the parallel rod in the
same way as the lower end.
11
Continues on next page
3HAC039838-001 Revision: C 249
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.4.7 Replacing the parallel rod
Continued
To Next Page
Loading...
