NoteAction
xx1000001111
Remove the plastic screws in the upper end of
the balancing device.
4
Insert two screws, M12x50 in the holes to
neutralize the spring force. Screw in the screws
until they have proper contact with the cylinder
inside.
5
The length of the cylinder is now locked and
the balancing device is unloaded. It should now
be possible to easily rotate the balancing
device.
xx1000001112
Attach a lifting accessories to the balancing
device.
Use the hole in the lifting ear.
6
Continues on next page
3HAC039838-001 Revision: C 267
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.5.1 Replacing the balancing device
Continued
To Next Page
Loading...
