NoteAction
CAUTION
The gearbox weighs 69 kg! All lifting
equipment used must be sized accordingly!
3
Specified in Required equipment on
page 311.
Fit the lifting accessory to the gearbox and
lift it with an overhead crane.
4
Art. no. is specified in Required equipment
on page 311.
Fit a new sealing to the gearbox and secure
it to the gearbox by using two guide
sleeves.
5
Axis 2:
xx1100000621
When refitting axis 2 gearbox:Insert the
guide sleeves in the two middle holes of
the upper screw areas.
When refitting axis 3 gearbox: Insert one
guide sleeve in the middle screw hole in
the upper back area and one guide sleeve
in the middle screw hole in the the lower
area.
Axis 3:
xx1100000622
Specified in Required equipment on
page 311.
Lubricate necessary surfaces of the gear-
box with grease in order to make it easier
to insert the gearbox into the frame.
6
Continues on next page
318 3HAC039838-001 Revision: C
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.7.2 Replacing the gearbox, axes 2- 3
Continued
To Next Page
Loading...
