110 Fault tracing
• A clear description of the symptoms that you can observe, for example the Status
LED, error messages displayed in Mint WorkBench, or errors reported by the Mint
error keywords ERRORREADCODE or ERRORREADNEXT.
• The type of motion generated in the motor shaft.
• A list of any parameters that you have setup, for example the motor data you
entered/selected in the Commissioning Wizard, the gain settings generated
during the tuning process and any gain settings you have entered yourself.
Power-cycling the MicroFlex e190
The term ‘power-cycle the MicroFlex e190’ is used in the Troubleshooting sections. If
the mains AC supply (or DC supply) is removed, wait for 2 minutes before reapplying
the supply.
To Next Page
Loading...
