ABB MicroFlex e190 - Electrical Installation: AC Input; DC Input, Motor and Brake

Electrical installation: AC input / DC input, motor and brake 49
6
Electrical installation:
AC input / DC input, motor
and brake
What this chapter contains
The chapter describes how to connect input power cables, motor and brake resistor.
WARNING! The work described in this chapter may only be carried out by a
qualified electrician. Follow the instructions in chapter Safety on page 13.
Ignoring the safety instructions can cause injury or death.

Make sure that the drive is disconnected from the input power during
in
stallation. If the drive is already connected to the input power, wait for 5
minutes after disconnecting the input power.