Disconnecting the antenna
Note/IllustrationAction
Note
The Connected Services antenna is installed
by the customer, and the cable routing can
therefore differ.
Record the cable routing when you re-
move the antenna cable from the cabinet.
1
xx2300000672
Disconnect the antenna cable from the
Connected Services gateway by rotating
the connector.
2
Remove any cable ties and protection.3
xx2200001973
Pull the cable out through the cable
grommet.
4
Remove the magnet part of the antenna
from the cabinet.
5
Continues on next page
218 Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.5 Replacing the 4G Connected Services gateway
Continued
To Next Page
Loading...
