Removing the Connected Services gateway
Note/IllustrationAction
Disconnect all connectors from the unit
to be replaced.
1
xx2300000753
Disconnect the free ends of the 24V ad-
apter harness:
• Wire K7-W201 from the 24V (V+)
connection on the Connected
Services gateway.
• Wire K7-W202 from the 0V (V-)
connection on the Connected
Services gateway.
2
Note
Press down the white button with a sharp
object while pulling out the wire.
Carefully lift the Connected Services
gateway slightly and then pull it out from
the bracket.
3
Continues on next page
Product manual - OmniCore V400XT 219
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.5 Replacing the 4G Connected Services gateway
Continued
To Next Page
Loading...
