ABB OmniCore V400XT - Page 319

Refitting the LED indicator
Refitting the LED indicator
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
Insert the LED indicator into the cover
from outer side of the door and the screw
from inner side and screw them up.
3
xx1900001926
Insert the terminals (X1 & X2) of cables
into the lamp and secure with the screws.
4
Concluding procedure
Note/IllustrationAction
Closing the door on page 183.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 171.
2
Product manual - OmniCore V400XT 319
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.3.6 Replacing the LED indicator
Continued