ABB OmniCore V400XT - Page 462

H
hanging
installed hanging, 28
hazard levels, 16
hazardous material, 340
height
installed at a height, 28
hold-to-run, 24
hot surfaces, 32
HRA, 28
I
I/O connectors, 104
industrial network, 113
installation activities, 54
installation space, 58
instructions for assembly, 53
integrator responsibility, 28
internal I/O
installing, 116
replacing, 223
J
jogging not possible, 360
joystick not working, 360
K
key of the mode switch, 31
L
labels
controller, 18
lead
disposal, 340
LED
additional drive unit, 376
Connected Services Gateway, 396, 402
drive unit, 369
Ethernet switch, 413
main computer, 414
power unit, 382, 389
LEDs , indication, 346
LEDs not lit, 346
licenses, 49
lifting device, 55
limitation of liability, 13
Lithium
disposal, 340
lock and tag, 29
M
main computer
replacing, 231
main power supply, 105
maintenance schedule, 159
manipulator cables, 80
manual full speed mode, 25
manual high speed mode, 25
manual mode, 25
manual reduced speed, 25
mode switch key, 31
motor contactors
function test, 174
MTTF
D
, 14
N
national regulations, 28
network security, 48
noise, 363
normal operation mode, 361
O
ODVA, 420
ODVA power supply
LED, 420
open source software, OSS, 49
operating conditions, 39
operating mode
automatic mode, 27
function test, 172
manual full speed mode, 25
manual mode, 25
manual reduced speed, 25
optional power supply
installing, 131
original spare parts, 13
P
path accuracy, 363
pedestal
installed on pedestal, 28
performance level, PL, 14
personnel
requirements, 15
PFH
D
, 14, 43–44
PL, performance level, 14
plastic
disposal, 340
power distribution board
connectors, 91
power failure during start-up, 349
power supply, 419–420
replacing, 251
power supply optional
installing, 131
power unit
LED, 382, 389
replacing, 242
test equipment, 383, 390
troubleshooting flowchart, 384, 391
PPE, 15
problem releasing the robot brakes, 353
processor board
connectors, 93
process power supply, 419
DC OK, 419
LED, 419
product standards, 422
protection classes, 39
protection type, 39
protective earth, 84
protective equipment, 15
protective stop
definition, 21
protective wear, 15
R
RCD, 83
recovering from emergency stops, 23
recycling, 340
reduced speed control
function test, 179
reflashing firmware failure, 362
regional regulations, 28
462 Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
Index