ABB PCS100 AVC-20 - User Interface; Graphic Display Module (GDM)

30 PCS100 AVC-20 User Manual
—
6 USER INTERFACE
6.1 Graphic Display Module (GDM)
The primary user interface for configuration of the PCS100 AVC-20 is via the Graphic Display Module (GDM) which
is mounted in the door of the Master Controller Enclosure. It allows local control of the PCS100 AVC-20 and shows
the system status and provides access to the operating parameters and event history.
The GDM interface consists of several pages; each page has Navigation & Control Panel and Status Bar at the top.
The Navigation, Control Panel and the Status Bar are displayed at all times.
The Navigation Panel consists of buttons allowing page selection and the control panel consists of a Start (I) /
Stop (O) / Reset button allowing local control of the product.
The Status Bar displays the current product status and any warning or fault condition that may be present.
Table 6-1 describes general features of GDM, and Figure 6-1 displays Status page of GDM.
Feature
GDM
Display resolution
1024 x 600 pixels
Display size
10.1”
Color graphic display
yes
Touch sensitive display
yes
Full descriptions of status and faults
yes
Local Start/Stop Reset Control
yes
Status Display
yes
Parameter adjustment
yes
Number of Event Log records stored
10000
Event log can be downloaded to a PC
yes
Remote Web Pages
yes
Modbus TCP connection
yes
Multilanguage selection
yes
Table 6-1: PCS100 AVC-20 GDM features
The GDM screen consists of following parts:
1. Navigation & Control Panel
2. Status Bar
3. Page (selectable)