ABB PCS100 AVC-20 - Menu 3 Product Revision

PCS100 AVC-20 User Manual 59
Parameter:
24 Relay Test Mode
Function:
Turns relays on and off.
Access:
Tech
Range:
7 test options
Default:
off
Parameter:
25 RMS Line Gnd Test
Function:
Changes status page voltage readings from L-L to L-G
Access:
Tech
Range:
True / False
Default:
False
Note:
For calibration of voltage sensors
Parameter:
26 GDM Remote Menus
Function:
Enables remote access to the GDM menus via the GDM Ethernet connection
Access:
Tech
Range:
True / False
Default:
False
Note:
If enabled, allows an operator to remotely configure the PCS100 AVC-20.
Parameter:
27 Auto Start
Function:
Allows the system to assume it previous run state after system power is lost.
Access:
Tech
Range:
No Auto Start = Do not auto start, Mem Auto Start = Auto start using volatile value,
Always Auto Start = Auto start using non-volatile value (Recommended)
Default:
No Auto Start
Table 8-4: Menu 2 Commissioning Parameters
8.3.5 Menu 3 Product Revision
3 Product Revision
The menu contains displays various PCS100 AVC-20 software numbers and revisions
Parameter:
30 System Product
Function:
Displays the product main software number.
Note:
For PCS100 AVC-20 this is “7300”
Parameter:
31 System Revision
Function:
Displays the main system software revision.
Note:
Products relating to this manual should be R2J4 revision or later.
Parameter:
32 SCM Boot Product
Function:
Displays the SCM (System Configuration Module) boot software name.
Note:
The PCS100 AVC-20 SCM Boot SW is “7605-010”
Parameter:
33 SCM Boot Revision
Function:
Displays the SCM (System Configuration Module) boot software revision
Parameter:
34 SCM Product
Function:
Displays the SCM (System Configuration Module) software number
Note:
The PCS100 AVC-20 SCM SW is “7600-810”