ABB PCS100 AVC-20 - Menu 7 GDM Services

PCS100 AVC-20 User Manual 61
8.3.7 Menu 7 GDM Services
7 GDM Services
The menu contains the status of various GDM services
Note: This menu is only visible with Operator or Tech login
Parameter:
71 Webserver Status
Function:
Displays the status of the webserver.
Access
Read Only
Range:
Should display “Running”
Note:
This parameter is not displayed if the webserver service is not available.
Parameter:
72 Vcanserver Status
Function:
Displays the status of the Vcanserver.
Access
Read Only
Range:
Should display “Running”
Note:
Vcanserver is the software module interfacing the CAN bus used by the PCS100 AVC-
20 master controller to the webserver in the GDM.
Parameter:
73 Modbus Service
Function:
Displays the status of the Modbus TCP Service
Access
Operator
Parameter:
74 NTP Status
Function:
Displays the status of the NTP (Network Time Protocol) client service.
Access
Read Only
Range:
Running clock updated” if the NTP server connection is successful.
“Invalid Server Name” if no NTP server IP address has been set.
“Server connection failed” if no response from the NTP server was received.
Note:
Wait at least 30 seconds after setting the NTP server IP address parameter 75 NTP
Server before refreshing menu 7 GDM Services.
The NTP Status field will be updated when entering the menu.
Parameter:
75 NTP Server
Function:
Sets the IP address of an NTP (Network Time Protocol) server.
Access
Tech
Range:
Any valid Ipv4 formatted IP address.
Setting Up:
Enter the IP address of the NTP server
Note:
Wait for at least 30 seconds before refreshing the 7 GDM Services menu to check
parameter 74 NTP Status.
Parameter:
76 NTP Time Zone
Function:
Sets the local time zone offset from UTC.
Access
Tech
Range:
±13 hours
Parameter
77 Email Service
Function:
Sets up the email notification service of power quality and system events.
Access
Operator
Table 8-7: Menu 7 GDM Services Parameters