ABB PCS100 AVC-20 - Submenu B00 Network Settings

PCS100 AVC-20 User Manual 65
8.3.8.2 Submenu B00 Network Settings
B00 Network Settings
This menu contains parameters to setup the GDM Ethernet port.
Name:
B11 Dynamic IP DHCP
Function:
Configures the Dynamic Host Configuration Protocol (DHCP). This is displayed on the
Product Page.
Range:
True = Dynamic. False = Static.
Access:
Operator
Setting Up:
The network may be configured using either static or dynamic configuration methods. The
static method is the simplest for a direct connection to a PC. The IP address for the GDM
is manually configured via parameter B12 Static IP address. The PC IP address in Windows
may also need adjusting. The Dynamic method is when the computer's IP address is
assigned automatically, in which case parameters B12 Static IP address and B13 Static IP
mask does not need to be entered. Dynamic IP addresses are most frequently assigned on
LANs and broadband networks by a Dynamic Host Configuration Protocol (DHCP) server.
On any but the simplest network the network administrator’s assistance will probably be
required. Parameter B15 Apply Settings must be set to TRUE to save this setting.
Name:
B12 Static IP address
Function:
Configures the GDM Static IP address.
Range:
###.###.###.### (where ### = 1 to 255)
Access:
Operator
Setting Up:
Parameter B15 Apply Settings must be set to TRUE to save this setting.
See section 10.2 for further setting up instructions.
Name:
B13 Static IP mask
Function:
Configures the GDM Static IP mask.
Range:
###.###.###.### (where ### = 1 to 255)
Access:
Operator
Setting Up:
Parameter B15 Apply Settings must be set to TRUE to save this setting.
See section 10.2 for further setting up instructions.
Name:
B14 Static IP gateway
Function:
Configures the GDM Static IP gateway.
Range:
###.###.###.### (where ### = 1 to 255)
Access:
Operator
Setting Up:
Parameter B15 Apply Settings must be set to TRUE to save this setting.
See section 10.2 for further setting up instructions.
Name:
B15 Apply Settings
Function:
Applies the network settings B11 Dynamic IP DHCP, B12 Static IP address, B13 Static IP
mask and B14 Static IP gateway. Select True to update the configuration.
Range:
True / False
Access:
Operator
Setting Up:
To view the actual settings currently used by the PCS100 AVC-20 see the Product Page in
section 6.1.5.
See section 10.2 for further setting up instructions.
Table 8-9: Submenu B00 Network Settings