ABB PCS100 AVC-20 - Page 56

56 PCS100 AVC-20 User Manual
CAUTION – Trained Operators
Damage to the PCS100 AVC-20 may occur if this parameter is set incorrectly
Parameter:
08 Set Parameter
Function:
Provides the ability make a custom adjustment to an internal parameter.
Access:
Continuous
Range:
True / False
Setting Up:
Enter the factory supplied code to change the required internal parameter. When a
correct code is entered the message “Parameter Write Result = OK” will be displayed.
If an incorrect code is entered the message “Sorry, value entered is not correct” is
displayed.
This parameter can also be accessed via the remote web pages – see section 10.2.6.2
Note:
The code must be entered exactly. Take care when emailing such codes. Different
characters look the same in some fonts. E.g., the lower-case letter L looks the same as
the numeral one in Times New Roman Font. The Arial Font is OK.
Parameter:
09 Show Faults
Function:
Shows all the faults and warnings presently active.
Access:
Continuous
Note:
Sometimes there can be more than 1 fault or warning active at one time. The most
critical fault is displayed on the Status line. This screen shows all the faults and
warnings presently active.
Parameter:
0A Color Theme
Function:
Allows the user to choose between the standard and classic color schemes
Access:
Continuous
Table 8-2: Menu 0 General Parameters