ABB Power2 850-M16 - Removing the Filter Silencer

Operation Manual / Power2 850-M / 4.1 Low-pressure stage
4
Disassembly and assembly
Page 15 /
49
© Copyright 2015 ABB. All rights reserved.
HZTL4062_EN
Revision -
December 2015
4.4 Removing the filter silencer
 Dismantle insulation as far as necessary.
 If present: Disconnect supply line for compressor cleaning from filter silencer.
Figure 5: Removing the filter silencer
1. Fit the swivel lifting eye (90231) to the silencer (81000). Attach the lifting gear to the swivel
lifting eye (90231) and loop through the eyelets at the rear of the filter silencer (81000).
2. Loosen and remove nuts (72004). Remove washers (72003).
3. Remove and put down filter silencer.
4. Loosen and remove nuts (77022). Remove sleeves (77023).