ABB Power2 850-M16 - Axial Clearance a Prior to Disassembly

Operation Manual / Power2 850-M / 4.1 Low-pressure stage
4
Disassembly and assembly
Page 16 /
49
© Copyright 2015 ABB. All rights reserved.
HZTL4062_EN
Revision -
December 2015
4.5 Axial clearance A prior to disassembly
CAUTION
Clearances outside the tolerance
Serious damage to engines or property can be caused by clearances
outside the tolerance and excessively worn parts.
 Have the components assessed and, if necessary, replaced by an ABB
Turbocharging Service Station.
Figure 6: Measuring axial clearance A
The axial clearance (A) must be measured prior to removal and after installation of the
cartridge group.
 Measure and note axial clearance (A).
Axial clearance A
[mm]
0.32 ... 0.53
Table 6: Axial clearance A