ABB Power2 850-M16 - Installing the Air Suction Branch

Operation Manual / Power2 850-M / 4.1 Low-pressure stage
4
Disassembly and assembly
Page 34 /
49
© Copyright 2015 ABB. All rights reserved.
HZTL4062_EN
Revision -
December 2015
4.16 Installing the air suction branch
Figure 30: Installing the air suction branch
Part number
Thread and tightening torque
72004 M16
200 Nm
Table 16: Tightening torque (72004)
1. Remove the two opposing nuts (72004) and washers (72003) that were used to secure the
wall insert.
2. Loop around air suction branch (82000) with lifting gear.
3. Position the air suction branch.
4. Fit nuts (72004) with washers (72003) and tighten nuts (72004).
 Reinstall dismantled insulation.
 Reinstall all air lines according to the instructions of the enginebuilder.