58
FEM630 | ELECTROMAGNETIC FLOWMETER | OI/FEM630-EN REV. A
40 Use to switch to the process display.
...7 Commissioning
Easy Setup
Note
• Prior to starting the zero point adjustment, make sure
that:
• There is no flow through the sensor (close all valves, shut-
off devices etc.)
• The sensor is completely filled with the medium to be
measured
• Use to start automatic adjustment of the zero point
for the system.
Once all parameter have been set, the main menu appears
again. The most important parameters are now set.
Menu
Easy Setup
Exit Select
Easy Setup
Next Ok
To Next Page
Loading...
