84
FEM630 | ELECTROMAGNETIC FLOWMETER | OI/FEM630-EN REV. A
Menu / parameter
Device Setup / ...Transmitter / ...Units
Unit Massflow Qm
Selection of unit for mass flow.
Refer to
The selection applies to the display of the current mass flow, and for the parameters related to mass flow such
as QmMax and Qm
Max
DN.
Unit Mass Tot.
Select the unit for the mass totalizer.
Refer to
Unit Volumeflow Qv
Selection of unit for volume flow.
Refer to
The selection applies to the display of the current volume flow and for the parameters related to volume flow
such as QvMax and Qv
Max
DN.
Unit Vol. Totalizer
Selection of unit for the volume totalizers.
Refer to
Selection of the unit for external process variables.
The transmitter can show two external process variables in the display. The process variables can be
transferred from the fieldbus master to the transmitter via the HART, Modbus or PROFIBUS DP protocol. You
can configure the display through the ’Display’ menu.
Cust Qm Unit N. Enter the name for the user-defined mass flow unit.
Cust Qm Unit F. Enter the factor for a user-defined mass flow unit. The factor relates to the flow per liter.
Cust Qm Tot Unit N. Enter the name of the user-defined totalizer unit for mass flow.
Cust Qm Tot Unit F. Enter the factor for a user-defined mass flow unit. The factor relates to the flow per liter.
Cust Qv Unit N. Enter the name for the user-defined volume flow unit.
Cust Qv Unit F. Enter the factor for a user-defined volume flow unit. The factor relates to the flow per liter.
Cust Qv Unit N. Enter the name for the user-defined volume flow unit.
Cust Qv Tot Unit F.
Enter the factor for a user-defined volume flow unit.
The factor relates to the flow per gallon.
Device Setup / ...Transmitter / ...Cut Off
Low Flow Cut Off
the low flow cut-off.
Low Flow Hysteresis
8 ...Operation
...Parameter descriptions
To Next Page
Loading...
