90
FEM630 | ELECTROMAGNETIC FLOWMETER | OI/FEM630-EN REV. A
Menu / parameter Description
General Alarm
Only if the parameter ‘Logic Output Action’ is set to Alarm Signal.
Qv Volumeflow Max
Qv Volumeflow Min
EPD
TFE
Gas Bubble
Conductivity
Sensor Temperature
In house Temp
Mode
output.
• Off: Digital output deactivated.
• Logic: Digital output functions as binary output (for function see parameter ‘...Setup Logic Output’).
•
depends on the setting of the parameter ‘Outp. Flow Direction’.
•
•
Outp. Flow Direction
Selection of flow direction in which the pulse / frequency output issues the selected process value.
‘Mode’.
• No pulses are issued if ‘Forward & Reverse’ is selected. Only digital output 41 / 42 is active.
• When ‘Forward’ is selected, pulses for forward flow are issued at digital output 41 / 42 and pulses for re-
verse flow at digital output 51 / 52.
• When ‘Reverse’ is selected, pulses for forward flow are issued at digital output 41 / 42 and pulses for re-
verse flow at digital output 51 / 52.
...Setup Logic Output
Selection of submenu ‘...Setup Logic Output’ using .
Only available if ‘ModeLogic’ has been selected.
...Alarm Config
Selection of submenu ‘...Alarm Config’ using .
Only available if ‘ModeLogic’ has been selected.
8 ...Operation
...Parameter descriptions
To Next Page
Loading...
