42 OI/FEP610/FEH610-EN Rev. B | ProcessMaster FEP610, HygienicMaster FEH610
Once you have logged on to the corresponding access level,
you can edit or reset the password. Reset (status "no
password defined") by
selecting " " as a password.
Enter Password
**********
QRSTUVWXYZ
Next OK
4. Enter the corresponding password (see chapter """ on
page 43"). No password is preset in the factory settings.
Users can switch to the configuration level without
entering a password.
The selected access level remains active for 3 minutes.
Within this time period you can toggle between the
process display and the configuration level without re-
entering the password.
5. Use to confirm the password.
The LCD display now indicates the first menu item on the
configuration level.
6. Select a menu using / .
7. Confirm the selection with .
7.3.5 Selecting and changing parameters
Entry from table
When an entry is made from a table, a value is selected from a
list of parameter values.
Menu name
Parameter name
Currently set value
Next Edit
1. Select the parameters you want to set in the menu.
2. Use to call up the list of available parameter values.
The parameter value that is currently set is highlighted.
Parameter name
Parameter 1
Parameter 2
Parameter 3
Cancel OK
3. Select the desired value using / .
4. Confirm the selection with .
This concludes the procedure for selecting a parameter value.
Numerical entry
When a numerical entry is made, a value is set by entering the
individual decimal positions.
Menu name
Parameter name
12.3456 [unit]
Next Edit
1. Select the parameters you want to set in the menu.
2. Use to call up the parameter for editing. The decimal
place that is currently selected is highlighted.
To Next Page
Loading...
Need help?
General
